For Canon LCD/touchscreen equipped printer models which do not have physical buttons, you may need to lift the cartridge access door/lid to illuminate the ‘Stop’ button, then PRESS AND HOLD the ‘Stop’ button for approximately 8 seconds to reset the printer.After refills, the printer cannot track the ink level ink level indicator will falsely signal empty.
Touchscreen Printer Models – Reset Procedure: ‘Grayed-out’ ink tanks will be displayed on the LCD screen or Windows pop-up screens when ink levels are checked – this is NORMAL. NOTE 1: “ Empty” and “ Low Ink” alerts are COMPLETELY NORMAL for all Canon 250, 251, 250XL, 251XL, 550, 551, 550XL & 551XL ink cartridges which have been refilled! While at first this may be an unusual workflow, it does allow print operations to proceed, however you must first enable ink level monitoring to be released. Refer to applicable section below for reset instructions. If you refilled your ink cartridge at one of our retail refill labs then the Canon cartridge chips should have been reset via the Canon C2 Resetter (special photo lab equipment) and ink level monitoring will be available – you may disregard the information below unless you observe flashing lights or low ink error messages. If you need to manually bypass the alerts then perform the following steps. Your printer/computer may display ink alert messages, such as “remaining ink cannot be correctly detected” – you can bypass this message by either pressing the Stop/Resume function (button) within the Touchscreen menu options or by selecting ‘Yes’ via the Windows driver pop-up messages (if full printer driver is installed). Remove protective cap and insert cartridge into your printer.
0 kommentar(er)
